One of the most effective ways to keep your kids protected near the pool is by installing a pool fence. In some parts of the globe, installing a pool fence is considered a legal requirement for every pool owner.
However, installing a pool fence on your own can be a stressful job. There are numerous things that you need to consider. If things go wrong, you will end up risking your kid’s life. We recommend hiring pool fence installers in Sydney to install a pool fence properly.
This blog post will help you get an idea about the most crucial things you need to consider while installing a pool fence properly.
Before the installation
Here are a few essential things to keep in mind before you install the pool fence. Read on to know more.
See the location- The first thing you need to figure out is the location where you want to install the fence. You need to ensure that the chosen location does not have any underground cable line for gas, electricity, or water. That is mainly to avoid any problems like hitting underground cables or pipes while installing the pool fence.
Get the tools ready- Tools that the pool fence installers in Sydney will include an electric drill, screwdriver, post hole digger, gloves, chalk/pencil, tape measure, concrete mix, spirit level, and a string.
When you are all set with the nuances mentioned above, you can shift to the installation part. However, you need to understand that the installation steps mentioned below might vary depending on the type of fence you are installing.
Installation steps
There are several ways to install a pool fence. Here we present a simple installation process.
Plan and set up - Before you start; do not forget to check the pool fence specifications in your country. You should clean the area that you are planning to fence. You should also measure the area. In the next step, you need to determine how far each post goes, and you can mark the spot with chalk. You need to excavate holes that are at least 600mm deep.
Attaching the panels and posts - you should try to position the posts in the holes and fill them with concrete mix. Once the process is over, you can attach the brackets to the end of the fence rails and then screw them to the post. You need to do this for both sides of the post.
Install the pool safety gate - try to fix the hinges of the gate to the post. Remember that the gate will open outwards. You can try to place the gate on wooden planks to make sure the gaps and the heights are correct. After that, lock the gate to the post and fix the gate lock. Check whether the gate closes appropriately.
The finishing touch - You should clean the area and remove any wooden blocks from the fence. Leave the cement to dry. Backfill some soil from above to cover the exposed cement.
To conclude
As a pool owner, you need to pay attention to every small detail. To ensure there is no unwanted problem while installing the pool fence, you can work with a group of reliable pool fence installers in Sydney.
Comments
Post a Comment